Ordered before 2pm, shipped same day. Shipping costs are displayed in the shopping cart.
Pre-coloured, gel-like 2-component epoxyacrylate-based adhesive in different colours, high bonding power, very fast surface drying and processability, foodsafe (certified by an external German testing institute, working time approx. 5 - 7 min (20°C), mixing ratio 10:1
For the fast, simple and reliable attainment of invisible joints for quartz and natural stone. The more than 50 Colour Bond colours are identical to those of the 1-component sealant COMPOSIL (same colour codes) for expansion and connection joints on composite stone (AKEMI COLOUR MATCHING SYSTEM). Colour charts for the different composite stones of all renowned manufacturers (e.g. Silestone®, Caesarstone®, Zodiaq®, TechniStone®, Quarella, Cambria®, Okite®, Compac, Diresco, Hanstone etc.). Within the EU: subject to the self-service prohibition regulation and shall only be sold by specialised sales outlets.
Instructions for use
Make sure the surface is clean, completely dry and slightly roughened.
Remove the cap from the cartridge and place the cartridge in the gun.
Squeeze until adhesive comes out of both openings.
Screw the mixing nozzle onto the cartridge. Do not use the first 10 cm of adhesive from the nozzle.
Apply the adhesive. At 20 °C it remains workable for 5 to 7 minutes.
After 20 to 30 minutes at 20 °C, the adhesive is hard enough to be sanded, drilled or milled.
Tips
Colour Bond comes pre-coloured in more than 50 shades, for an almost invisible joint. Our colour matching service helps you find the right shade.
Suitable for composite, natural stone and ceramics, including large-format ceramics such as Dekton, Neolith and Laminam.
Heat speeds up curing, and cold slows it down considerably.
Keep adhesive layers as thin as possible, under 1 mm.
After use, you can leave the mixing nozzle on as a seal. The adhesive will harden inside it, so replace it with a new nozzle next time. Alternatively, remove the nozzle and close the cartridge with its cap. Before each new use, first check that adhesive comes out of both openings.
Caution
Use only original AKEMI mixing nozzles.
Do not use adhesive that has thickened, become lumpy or is starting to gel.
Outdoors, where it is often exposed to moisture and frost, its durability is limited.
Adhesion is weaker on fresh, alkaline substrates such as concrete.
P501:
P280:
P305+351+338:
H302:
H319:
P261:
P273:
H410:
H317: May cause an allergic skin reaction.
P302+352: IF ON SKIN: Wash with plenty of water.
P333+313: If skin irritation or rash occurs: Get medical advice/attention.